If you search the keywords “tint near me,” you would know that window film installation around Winter Park FL can be very beneficial.
For those wondering how to tint windows near Winter Park FL, this can be your ultimate guide to doing so.
Preparation of Materials
Northern window tint near Winter Park FL offers a lot of pre-cut window tint for boats around Winter Park FL.
But whether it is a boat window or boat bathroom window film near Winter Park FL, you can simply search for window tint shops near you to get your hands on some quality films. You’re going to need a window tint solution, a razor knife (optional), a clean cloth, a scraper blade, a heat gun (optional), and a squeegee.
It is important to find a dust-free location for where you can apply your window films, not excessively hot nor cold (preferably, a garage), and be sure to check your local state tinting laws so as to make sure that you are not violating any rules.
Step by Step Process
Here are the steps that will help you in your “DIY tint near me” search:
1. Apply the window tint solution inside the glass windows.
2. Carefully run the scraper blades from side to side of the glass windows. You can start from the top and work your way gently towards the bottom.
3. Using the squeegee, run it across the glass windows from side to side. This will remove any leftover debris.
4. Apply the window tint solution outside the glass windows.
5. Roll the window tint over the window. You can check the image by searching “how to apply tint near me.”
6. The window tint solution will keep the film in place. Run the squeegee over the film so as to make sure it will not move.
7. For sliding glass windows, make sure you round the edges off with your fingers.
8. Fix the window film on the corner on the side of the glass windows using a piece of clear tape.
9. With the clear tape, you can start to peel the protective lining of the window film.
10. Spray the adhesive surface with the application solution as you go about peeling it off.
11. Discard the liner and remove the window film from outside the window.
12. Make sure that you fold the edge of the bottom part of the film so that it would not touch the door trim.
13. Move the film into place and make sure you leave about 1/8-inch gap from the top.
14. Flatten it out starting from the middle and working yourself outwards so as to avoid any trapped bubbles.
15. Wrap the squeegee in the free cloth and run it across the whole glass windows.
The purpose of the last step would be to allow any excess or remaining application solution to be absorbed by the cloth. If you search “tint near me,” you would know that bubbles are the enemies of window tint application, you may opt to use the heat gun to warm the area to remove the bubbles.